HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Installation Instructions

information about interconnect module options, see the HP website
(http://www.hp.com/go/bladesystem/interconnects).
Installing a workstation blade
CAUTION: To prevent improper cooling and thermal
damage, do not operate the workstation blade or the
enclosure unless all hard drive and device bays are
populated with either a component or a blank.
1. If you are installing a workstation blade, remove a device bay
blank as shown here. If you are installing a workstation blade
with the graphics expansion blade, remove two successive
device bay blanks.
2. oIf you are installing a workstation blade, remove the power
connector cover as shown here. If you are installing a
workstation blade with the graphics expansion blade, remove
the power connector covers.
3. If you are installing the workstation blade, prepare it for
installation.
4. If you are installing the workstation blade with the graphics
expansion blade, prepare it for installation.
5. Install the workstation blade, as shown here, or the workstation
blade with the graphics expansion blade.
Completing the configuration
To complete the workstation blade and HP BladeSystem
configuration, see the overview card that ships with the enclosure.