HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 44
To replace the component, reverse the removal procedure.
Mezzanine card
Optional mezzanine cards enable network connectivity or provide Fibre Channel support. For mezzanine
card locations, see the system board components (on page 83).
Because mezzanine cards are supported on multiple workstation blade models, the mezzanine card may
have captive screws that are not required to secure it to the workstation blade. When installing a mezzanine
card in this workstation blade, only two captive screws are required.
To remove the component:
1. Power down the workstation blade.
2. Choose one of the following options:
o Remove the workstation blade (on page 27).
o If you are using the WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade:
i. Remove the WS460c Graphics Expansion Blade access panel ("Removing the WS460c
Graphics Expansion Blade access panel" on page 29).
ii. Remove the WS460c Graphics Expansion Blade ("Removing the WS460c Graphics Expansion
Blade access panel" on page 29).
3. Remove the access panel ("Access panel" on page 28).
4. Remove the mezzanine card.