HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 45
To replace the component:
1. Install the mezzanine card. Press down on the connector to seat the board.
2. Install the access panel ("Access panel" on page 28).
3. Choose one of the following options:
o Install the workstation blade.
o If you are using the WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade,
install the graphics expansion blade, the graphics access panel, and the blade assembly.
Hard drive backplane
To remove the component:
1. Power down the workstation blade.
2. Remove the workstation blade (on page 27).
3. Remove the access panel ("Access panel" on page 28).
4. Remove all hard drives ("Hard drive" on page 39).
5. Remove all hard drive blanks ("Hard drive blank" on page 39).
CAUTION: Remove all hard drives and hard drive blanks before removing the hard drive
backplane.