HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 53

Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.

4. Install the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page

46).

5. Install the hard drive backplane ("Hard drive backplane" on page 45).

6. Install the hard drives ("Hard drive" on page 39).

7. Install the hard drive blanks ("Hard drive blank" on page 39).

8. Install the access panel ("Access panel" on page 28).

9. Install the workstation blade.

Processor

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION: To prevent possible server malfunction, do not mix processors of different speeds or

cache sizes. Refer to the label on the processor heatsink for a description of the processor.

CAUTION: To prevent possible workstation blade overheating, always populate each processor

socket with a processor socket cover and a heatsink blank or a processor and a heatsink.

IMPORTANT: Processor socket 1 must always be populated. If processor socket 1 is empty, the

workstation blade does not power up.

To remove the component:

1. Update the system ROM.

Locate and download the latest ROM version from the HP website (http://www.hp.com/support).

Follow the instructions on the website to update the system ROM.

2. Power down the workstation blade.

3. Remove the workstation blade (on page 27).