Manualshelf

HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

ManualsBrandsHP ManualsComputer AccessoriesHP BLc3000 Enclosure with 4 AC Power Supplies 6 Fan Trial ICE License
51525354555657585960
Removal and replacement procedures 58
5.
Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
6. Install the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
46).
7. Install the hard drive backplane ("Hard drive backplane" on page 45).
8. Install the hard drives ("Hard drive" on page 39).
9. Install the hard drive blanks ("Hard drive blank" on page 39).
10. Install the access panel ("Access panel" on page 28).
11. Install the workstation blade.
System board
To remove the component:
1. Power down the workstation blade.
2. Remove the workstation blade (on page 27).
3. Remove the access panel ("Access panel" on page 28).
4. Remove all hard drives ("Hard drive" on page 39).
5. Remove all hard drive blanks ("Hard drive blank" on page 39).
6. Remove the hard drive backplane ("Hard drive backplane" on page 45).
7. Remove the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
46).
8. Remove all DIMMs.
9. Remove all mezzanine cards, if installed ("Mezzanine card" on page 44).
10. Remove the heatsink ("Heatsink" on page 51).