HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 69
8.
Remove the workstation blade release lever.
To replace the component, reverse the removal procedure.
Release button
To remove the component:
1. Power down the workstation blade.
2. Remove the workstation blade (on page 27).
3. Remove the access panel ("Access panel" on page 28).
4. Remove all hard drives ("Hard drive" on page 39).
5. Remove all hard drive blanks ("Hard drive blank" on page 39).
6. Remove the hard drive backplane ("Hard drive backplane" on page 45).
7. Remove the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
46).
8. Remove the system board ("System board" on page 58).
Removing DIMMs, heatsinks, processors, and mezzanine cards is not required for this procedure.