HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade User Guide

Operations 16
CAUTION: To prevent damage to electrical components, properly ground the workstation blade
before beginning any installation procedure. Improper grounding can cause ESD.
Install the access panel
1. Place the access panel on top of the workstation blade with the hood latch open. Allow the panel to
extend past the rear of the workstation blade approximately 0.8 cm (0.2 in).
2. Engage the anchoring pin with the corresponding hole in the latch.
3. Push down on the hood latch. The access panel slides to a closed position.
Remove the DIMM baffle
To remove the component:
1. Power down the workstation blade.
2. Remove the workstation blade (on page 15).
3. Remove the access panel (on page 15).
4. Remove the DIMM baffle.
Removing the WS460c Graphics Expansion Blade
access panel
1. Lift the access panel latch (1). The access panel slides to the rear (2).