Manualshelf

HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade User Guide

ManualsBrandsHP ManualsComputer AccessoriesHP BLc3000 Enclosure with 4 AC Power Supplies 6 Fan Trial ICE License
11121314151617181920
Operations 17
2.
Remove the access panel.
To replace the access panel:
1. Align the anchoring pins on the access panel with the J-slots at the rear of the expansion blade
enclosure.
2. Lower the access panel on top of the expansion blade with the latch open.
3. Push down on the access panel latch. The access panel slides to a closed position.
Removing the WS460c Graphics Expansion Blade
1. Remove the access panel. For more information, see "Removing the WS460c Graphics Expansion
Blade access panel (on page 16)".
2. Disconnect the four PCIe/SAS cables from the PCIe riser board, noting their location for reinstallation.
3. Remove the two Torx-15 screws that secure the Graphics Expansion Blade to the workstation blade (1).