HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade User Guide

Hardware options installation 37
12.
Remove the thermal interface protective cover from the heatsink.
13. Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
14. Install all DIMM baffles.
15. Install the access panel (on page 16).
16. (Optional) Reinstall the WS460c Graphics Expansion Blade, and then the access panel.
Memory options
IMPORTANT: This workstation blade does not support mixing RDIMMs and UDIMMs.
Attempting to mix these two types causes the server to halt during BIOS initialization.
The memory subsystem in this workstation blade can support RDIMMs or UDIMMs. Both types are referred to
as DIMMs when the information applies to both types. When specified as RDIMM or UDIMM, the
information applies to that type only. All memory installed in the workstation blade must be the same type.