HP BladeSystem Onboard Administrator User Guide

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 128
Column Description
Click the autofill down arrow to assign the IP addresses.
Current Address
The current IP address of the device bay.
To save the EBIPA for IPv4 settings for the device bays, click Apply.
EBIPA for IPv4 Interconnect Bays tab
Interconnect Bays tab
The interconnect module management ports obtain IPv4 addresses on the management network in two ways:
• Dynamic IPv4 addressing
• EBIPA for IPv4 fixed DHCP addressing
Interconnect modules that have an internal management network connection to the Onboard Administrator
can obtain an EBIPA for IPv4-assigned address if configured.
Interconnect List
IMPORTANT: Do not use the 169.254.x.x range when configuring EBIPA-assigned addresses,
as this network address range is reserved for use by the Onboard Administrator.
Column Description
Bay
The bay in the enclosure of the interconnect device.
Enabled
Enables EBIPA for IPv4 settings for the interconnect bay. EBIPA for IPv4 settings for all
interconnect bays can be enabled by selecting the check box next to Enabled in the
heading row or individual interconnect bays can be enabled by selecting the check
box for that particular interconnect bay.
EBIPA Address
The fixed DHCP IP address you want to assign to the device bay.
Subnet Mask
Subnet mask for the device bays. Possible values are ###.###.###.### where ###