HP BladeSystem Onboard Administrator User Guide

First Time Setup Wizard 76
Field Possible value Description
IPv6 DNS 2
####:####:####:####:####:####:####:##
##/###, where #### ranges from 0 to FFFF and
the prefix /### ranges from 1 to 128. The prefix
is optional.
1
The IPv6 address for the second Static
IPv6 DNS server.
Static Default
Gateway
####:####:####:####:####:####:####:##
## where #### ranges from 0 to FFFF. A
compressed version of the same IPv6 address is
also supported. Do not specify a prefix. The
gateway is assumed reachable from within the
network.
1
The static IPv6 address for the IPv6
default gateway to be used by the
Onboard Administrator. This setting is
required in an IPv6 network
environment configured to be fully
static.
The Onboard Administrator can accept
IPv6 gateway configuration directly via
this setting and, if configured, via
Router Advertisements from IPv6 routers
on the management network. If Router
Advertisements provide IPv6 gateway
configuration, their gateway
configuration overrides the static IPv6
gateway setting. The IPv6 gateway
currently in use by the Onboard
Administrator is displayed in the
Current Default Gateway field on the
Active Onboard Administrator TCP/IP
Settings ("Active Onboard
Administrator TCP/IP Settings screen"
on page 177) screen and the Standby
Onboard Administrator TCP/IP Settings
screen.
Enable Dynamic
DNS
Enabled (check box selected) or disabled (check
box cleared).
Enables you to use a host name for the
Onboard Administrator. The host name
is registered with a DNS server.
Dynamic DNS updates the DNS server
with new or changed records for IP
addresses. This enables you to use the
same host name over time, although the
dynamically assigned IP address might
change.
3
1
A compressed version of the same IPv6 address is also supported.
2
The Onboard Administrator does not accept a link local address as an IPv6 Static address.
3
IPv6 Dynamic DNS requires that a valid DNS server (either IPv4 or IPv6) be configured on the Onboard Administrator.
To save the settings, click Next.