Full-Height Blade Blank and Device Bay Shelf Installation Instructions for HP BladeSystem c-Class Enclosures

Full-Height Blade Blank and
Device Bay Shelf
Installation Instructions
for HP BladeSystem c-Class Enclosures
Creating a full-height device bay
blank
1. Obtain the coupler plate:
o If you are using a device bay blank that shipped with the
enclosure, the coupler plate is in the full-height device
shipping box.
o If you are using a device bay blank that you purchased as
an option, remove the coupler plate from inside the blank.
2. Fit the coupler plate in to the slots on top of the blank, and
slide the coupler plate back until it snaps into place.
3. Fit the slots on the bottom of the second blank on to the tabs on
the coupler plate, and slide the second blank forward until it
snaps in place.
4. Install the full-height blank in to the device bay.
Removing a device bay shelf
1. Remove the blank.
c7000 Enclosure:
c3000 Enclosure:
2. Unlock the shelf locking tab.
c7000 Enclosure:
c3000 Enclosure:
3. Disengage the shelf from the enclosure.
c7000 Enclosure:
c3000 Enclosure:
4. Remove the shelf from the enclosure.
c7000 Enclosure:
© Copyright 2006, 2010 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
Part Number 411763-003
February 2010 (Third Edition)