Full-Height Blade Blank and Device Bay Shelf Installation Instructions for HP BladeSystem c-Class Enclosures

c3000 Enclosure:
Installing a device bay shelf
You must install the device bay shelf to support half-height devices.
To install the device bay shelf:
1. Remove the full-height server blade, storage blade, or device
bay blank.
c7000 Enclosure:
c3000 Enclosure:
2. Unlock the shelf locking tab.
3. Align the tabs on the shelf with the openings in the enclosure
and install the shelf.
CAUTION: Be sure that all five tabs (three on the left
side of the shelf and two on the right side of the shelf)
are fully engaged before sliding the shelf forward to
complete the installation. Failure to do so can cause
damage to server blade connectors during installation.
c7000 Enclosure:
c3000 Enclosure:
4. Pull the shelf forward until it stops and lock the shelf locking
tab.
c7000 Enclosure:
c3000 Enclosure:
The installation is complete.