DC Power Supply Installation Instructions - HP BladeSystem c7000 Enclosures

DC Power Supply
Installation Instructions
For HP BladeSystem c7000 Enclosures
© Copyright 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and
services. Nothing herein should be construed as constituting an
additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
December 2007 (First Edition)
Part Number AH332-9001A
*AH332-9001A*
Power supply bay numbering
Power supply LEDs
Power LED 1
(green)
Fault LED 2
(amber)
Condition
DC output on and OK On Off
DC present/standby
output on
Off On Power supply failure
Off Off No DC power to power
supply
Installin
g
a power supply
WARNING: Never attempt to install a DC power supply into
an AC input module. Doing so could cause damage to both
the input module and the power supply.
WARNING: To prevent damage to components in the
enclosure, never mix AC and DC power in the same enclosure.
Install the power supplies based on the total number of
supplies needed:
• Two power supplies: Bays 1 and 4