Intel Server Management (ISM) Installation and User's Guide, Version 5.5.5 - HP Carrier-Grade Server cc3310

Intel Server Management (ISM) Installation and User's Guide

Intel Server Management (ISM) Concepts

Linux Installation

Perform the following steps to install the One-Boot Flash Update Utility on a Linux system:

1. Verify that the w3c libraries distributed as part of Red Hat Linux are present on the system. If the w3c

libraries are not installed, install them according to Red Hat Linux documentation. (For example: on

RHEL 3.0 xxx was found on CD #2.)

2. Insert the ISM CD into the Linux server CD-ROM drive. (Be sure to mount the drive first.)

NOTE OFU is included in the ISM installation script. Refer to Installation of ISM for Managed

Linux Servers on page 15 for specific instructions.

3. Upon successful completion of the script, the utility and the flash update driver files will be located in

the /usr/local/flashupdt directory.

NOTE To run the One-Boot Flash Update utility, the working directory must first be set to the

directory in which the utility is installed. This is required because the utility depends on files

which are expected to be in the working directory.

Uninstalling the One-Boot Flash Update Utility from Linux Systems

To uninstall the One-Boot Flash Update utility from a Linux system, proceed as follows:

1. Log in as root.

2. Enter the commands listed below to uninstall the utility and supporting drivers:

• rpm –e ofudrvr

• rpm –e ipmidrvr (see note below)

• rpm –e flashupdt