Intel Server Management (ISM) Installation and User's Guide, Version 5.5.5 - HP Carrier-Grade Server cc3310

Intel Server Management (ISM) Installation and User's Guide

Serial Data and the Command Line Interface

6. Configure the session’s ASCII setup properties so that line ends are sent with line feeds and that lines

that exceed the terminal width do not wrap.

For detailed information on HyperTerminal, consult the Windows help system.

Using Windows HyperTerminal Console

To connect and use CLI commands:

1. Configure the session as described above.

2. At the Server: prompt provide the IP Address of the server to which you want to connect.

3. Provide a username if applicable. (This value is currently null. Press Enter.)

4. Provide a password, if applicable.

5. After authentication is performed, you will see a login successful message and the dpccli prompt. You

can now enter CLI commands.

Using Windows Command Prompt

To connect and use CLI commands:

1. Make sure that your PATH environment variable includes the dpccli.exe file. For a normal ISM

installation, dpccli.exe is located in the following directory:

C:\Program Files\Intel\ServerManagement\bin\cli

2. Enter the dpccli command and provide any command-line options (see page 66).

3. At the Server: prompt provide the IP Address or DNS Name of the server to which you want to connect.

4. Provide a username if applicable. (This value is currently null. Press Enter.)

5. Provide a password, if applicable.

6. After authentication is performed, you will see a login successful message and the dpccli> prompt. You

can now enter CLI commands.

Using Linux Shells

To connect and use CLI commands from your Linux command line shell:

1. Enter the following command and provide any command-line options (see page 66).

/usr/local/cli/dpccli

2. At the Server: prompt provide the IP Address or DNS Name of the server to which you want to connect.

3. Provide a username if applicable. (This value is currently null. Press Enter.)

4. Provide a password, if applicable.

5. After authentication is performed, you will see a login successful message and the dpccli> prompt. You

can now enter CLI commands.

Using Linux Telnet

For best results when invoking Serial Over LAN commands during a CLI session, start the connection using

a Red Hat Linux telnet session.

1. At the Linux command prompt type telnet xxx.xxx.xxx.xxx 623 Enter. The xxx represent the IP

address of the system running the Network Proxy. This may be the local system or a central network