Processor Installation and Replacement Procedure For the HP cc3310 Carrier Grade Server Manufacturing Part Number: A9870-90001 August 2003 Edition 2 E0803
Instructions: These instructions inform users of cc3310 systems of the processor installation and replacement /transfer procedures. IMPORTANT NOTE: The systems Sensor Data Records (SDR) must be reprogrammed every time the hardware configuration changes (any changes to memory, processors, power supplies, power cage, hot swap back plane, controller boards, or any hardware devices or Field Replaceable Units).
2. Aligning the pins of the processor with the socket, insert the processor into the socket. Note the triangle locator on the socket and the processor chip for proper orientation. Figure B Installing Processors 3. Lower the locking bar completely. Figure C Lowering the Locking Bar 4. Position the heat sink above the processor ensuring that the black THERMAL PAD (adhered to the bottom of the heat sink) is positioned directly over the processor.
5. Aligning the raised metal surfaces, place the heat sink on top of the processor. Figure D Installing the Heat Sink 6. Place the heat sink clip so the tab on the clip engages the slot on the heat sink. Position the clip so that the plastic tab on the retaining bracket in located in the narrow portion of the heat sink clip opening. (See A in Figure E) 7. Press one end of the clip down until it locks into position with the retainer block tab.
Figure E Installing the Heat Sink Clip Replacing/Transferring a Processor Use this procedure for replacing a defective processor, or for transferring processor(s) from a defective chassis to a replacement chassis. 1. Observe the safety and ESD precautions at the beginning of this chapter and the additional cautions given here. 2. Removing the fan assembly will make processor removal/installation much easier to accomplish.
7. Aligning the pins of the replacement processor with the socket, insert the replacement processor into the socket (See Figure B). 8. Lower the locking bar completely (See Figure C). 9. Follow the instructions packaged with your boxed processor for preparing the heat sink and processor for installation. 10. Position the heat sink above the processor while ensuring that the black THERMAL PAD is positioned directly over the processor. 11.
