Workgroup System and Cluster Platform Express Overview and Hardware Installation Guide

Figure E-1 c7000 PSUs
HP Cluster Platform Express supports high-voltage power connections (200V-240V). Power
requirements can be met by using up to eight single phase PDU’s per enclosure as shown in the
table below. PDU’s will be mounted in 0U positions.
US/JapanInternationalNumber of Enclosures
Three 24A PDUsTwo 32A PDUsOne enclosure
Five 24A PDUsFour 32A PDUsTwo enclosures
Eight 24A PDUsSix 32A PDUsThree enclosures
The power cords from the enclosure power supplies plug directly into the PDUs. The power
cords from the optional control node, TFT monitor, and the administration network switch plug
into a power strip that is connected into the second PDU (PDU2). If your configuration has an
optional InfiniBand interconnect, it is plugged into a second power supply that is also connected
to the second PDU.
114 Configuration Rules for CPE BladeSystems