HP 16/18-Port Cable Management Kit Installation Guide (538272-doc)

Figure 4 A Cable Management Bracket Holding 16 InfiniBand Uplink Cables
1
2
3
The following list describes the callouts shown in Figure 4:
1. Left rear rack column
2. 16 secured InfiniBand cables
3. One of the 16 releasable cable ties (completed assembly for 16-port switch shown)
Important:
You must install the HP BladeSystem c-Class enclosure cable management bracket to provide proper
strain relief for the InfiniBand cables.
To install the InfiniBand cables and secure them with the releasable cable ties, follow these steps:
1. Install the push-button mounts by pressing them upward into each hole in the cable management
bracket (see callout 4 in Figure 1).
2. Cable the lower InfiniBand switch first, as described in the hardware installation guide for the
switch.
3. To secure an InfiniBand cable (callout 1 in Figure 5) to the cable management bracket, slide
the releasable cable tie through the push button mount and around the InfiniBand cable (see
callout 2 in Figure 5) and through the releasable cable tie lock.
10 Installing the Cable Management Bracket