HP DL1000 Cable Management Kit Installation Guide (580771-doc)

Figure 1-1 Bracket Hardware
• The fasteners that are specified in Table 1-1.
Table 1-1 Fasteners (Supplied with Cabinet Mounting Hardware)
DescriptionTorqueFormatSizeQty.
Cage nut for M6 screwN/ASquare nutM6 cage nuts4
Machine screw25-30
in/lb
PosidriveM6 x 16mm pan
head screws
4
Cage nut for 10-32 screwN/ASquare nut10-32 cage nuts4
Machine screw25-30
in/lb
Posidrive10-32 x 0.625
cap screws
4
To prevent screws from becoming loose because of vibration, HP recommends that you use
an adjustable torque drive, set to the torque specifications given in the table above. Contact
your HP sales representative if any parts are missing.
Note:
This cable management bracket might also be adaptable for other cable management solutions
(consult your hardware installation documentation).
1.5 Required Resources
To install the HP cable management kit, you require the following resources:
• Tools:
— Screwdriver, #2 (medium) Phillips
— Cage-nut insertion tool (shipped with the rack)
— Marker pen or masking tape
• Other resources: InfiniBand cables (not included in this kit)
1.5 Required Resources 7