Integrity rx4640 Cable Bracket Installation Guide

For information about the rail kit, see the Installation Guide for Midweight Slide
Kit that is shipped with each HP Integrity rx4640 server.
1.6 Installing the Bracket
Install the bracket as follows:
1. Mount the bracket on the end of the rail, as shown in Figure 1-2:
Figure 1-2: Mounting the Bracket on the Rail
HPTC-0059
Left Rear
Rack Column
Cable Management
Bracket
RX4640 Left
Rail
a. Position the bracket on the end of the rail, as shown in Figure 1-2.
b. Use a flat-bladed screwdriver to secure the captive screw to the rail’s
threaded insert.
2. Attach the 3.5-inch strap as shown in Figure 1-3.
Figure 1-3: Attaching the 3.5-inch Strap
HPTC-0060
1
1
2
a. Position the strap on the bracket as shown in Figure 1-3.
b. Use a #2 (medium) Phillips screwdriver to secure the strap to the bracket’s
threaded hole, using an M5 x 10-mm machine screw.
3. Repeat steps 1 and 2 until all the brackets are installed for all servers in
the rack.
1.7 Cabling
Follow the cabling sequence instructions for your model of HP Cluster Platform.
(See Section 1.2 for the location of the HP Cluster Platform documentation.) The
HP Integrity rx4640 Cable Bracket Installation Guide 1-3