Linux Clusters QsNetII Cable Management Kit Installation Guide

Figure 4: Securing the Rear Bottom Bracket
M6 x 16mm
Screw (4X)
Rear of Rack
zk-2081
M6 Cage
Nut (4X)
5. Prepare the eight cable support bars for installation by retracting the
spring-loaded retainer pin at the top of each bar. Pull the pin down and rotate
it until the pin locks in the retracted position as shown in Figure 5.
Figure 5: Locking the Retainer Pin
Pin in Closed
Position
Pin in Open
Position
zk-2082
1
Y
X
6. Orient a cable support bar so that the cable support hooks are on the
right-hand side. Place the bottom of the bar between the flanges on the lower
bracket as shown in Figure 6, callout 1. Insert a pivot pin and secure it
loosely a few turns with your fingers as shown in shown in Figure 6, callout 2.
QsNet
II
Cable Management Kit Installation Guide 7