ProCurve 6400 CX4 Cable Management Kit Installation Guide (5991-7987)

Table 1-1 Fasteners
DescriptionTorqueFormatSizeQty.
Cage nut for M6 x 16 mm screw.N/ASquare NutM6 Cage Nuts8
Machine screw, Phillips drive. For use with the cage
nut.
30 in/lbPhillips
(Posidrive)
M6 x 16 mm
Screws
8
For use with the 10–32 screws.N/ANut, Clip10–32 Nuts8
Machine screw, pan-head. For use with the clip nut.30 in/lbPhillips
(Posidrive)
10–32 x 0.625
Screws
8
• Packaging and documentation.
To prevent screws from becoming loose due to vibration, HP recommends using an adjustable
torque driver set to the torque specifications shown in Table 1-1. If any parts are missing, contact
your HP sales representative.
1.5 Required Resources
To install the kit, you require the following resources:
• Tools:
— Screwdriver, #2 (medium) Phillips.
— Cage-nut insertion tool (shipped with the rack) or a flat-bladed screwdriver.
— Marker pen or masking tape.
• Resources: A sample cable of the type used by the system interconnect.
• Environment:
— A work surface adjacent to the rack.
— A stable work platform or step stool that lets you safely reach components installed in
the upper part of the rack.
8 Preparing for Installation