Tab Mount Cable Management Bracket Installation Guide

Figure 2-2: Attaching the Bracket
29
Y
X
Z
4. With a Torx T15 screwdriver, secure the bracket to the rail by using two 6-32
screws.
2.1.1 Installing the Strap
Use the following procedure to attach the strap to the bracket:
1. Position the strap on the bracket, as shown in Figure 2-3, so that it is
approximately adjacent to the interconnect card in the server’s PCI slot.
Figure 2-3: Attaching the strap
2
1
3
Y
X
Z
[
2. Clip an M6 cage nut into the bottom of the bracket’s slot, as shown by callout 1.
3. Insert an M6 x 16-mm screw through the metal grommet in the strap, as
shown by callout 2.
4. Use a #2 (medium) Phillips screwdriver to secure the strap loosely.
5. Perform this step only when fitting the first bracket to determine the correct
horizontal location of the strap.
Rotate the strap (callout 3) and move it horizontally in the elongated slot to
align it with the center of the port. Using a sample cable, align the strap so
that the cable’s connector (plug) is aligned correctly with the port.
Use the location of this first strap to determine the correct strap mounting
position for all subsequent bracket installations.
2-2 Installing the K it