Network and InfiniBand Cable Management Harness Installation Guide Used to Manage Network and InfiniBand Cables in HP 10000 Series 42U Racks HP Part Number: 572559-doc Published: September 2009
© Copyright 2009 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. InfiniBand™ is a trademark of the InfiniBand® Trade Association.
Table of Contents 1 Preparing for Installation................................................................................................7 1.1 Audience...........................................................................................................................................7 1.2 Documentation Resources.................................................................................................................7 1.3 Kit Description......................................................
List of Figures 1-1 2-1 4 Network and InfiniBand Cable Management Harness...................................................................8 Network and InfiniBand Cable Management Harness Orientation.............................................
List of Tables 1-1 Fasteners..........................................................................................................................................
1 Preparing for Installation 1.1 Audience This guide is intended for HP service representatives and other persons trained to install hardware options in HP 10000 Series Racks. Such persons are expected to understand the hazards of working in this environment and to take suitable precautions to minimize danger to themselves and others. 1.
Figure 1-1 Network and InfiniBand Cable Management Harness 1 2 3 4 5 6 7 The following list describes the callouts in Figure 1-1: 1. Top of the HP 10000 Series Rack 2. Top mounting bracket secured to the top of the rack with a #10-32 screw 3. Network and InfiniBand cable management harness mounted to top mounting bracket with two M6 screws 4. 6.5-inch Velcro strap 5. 13-inch Velcro strap 6. Bottom mounting bracket secured to the bottom of the rack with a #10-32 screw 7.
Note: This network and InfiniBand cable management harness might also be adaptable for other cable management solutions (consult your hardware installation documentation). 1.
2 Installing the Network and InfiniBand Cable Management Harness Figure 2-1 shows the correct orientation of the network and InfiniBand cable management harness. The location of the network and InfiniBand cable management harness depends on the location of the components and cables in the rack.
1. Determine where the network and InfiniBand cable management harness needs to be mounted in the rack (either in the middle or one of the sides). Note: More than one network and InfiniBand cable management harness might be necessary in some configurations. 2. 3.
