The Network and InfiniBand Cable Management Harness Installation Guide (572559-doc)

1. Determine where the network and InfiniBand cable management harness needs to be
mounted in the rack (either in the middle or one of the sides).
Note:
More than one network and InfiniBand cable management harness might be necessary in
some configurations.
2. Attach the top mounting bracket to one of the top mounting locations (see callouts 3 and 4
in Figure 2-1) using two #10-32 screws
3. Attach the bottom mounting bracket to one of the bottom mounting locations (see callouts
3 and 4 in Figure 2-1) using two #10-32 screws
Note:
If you attach the top mounting bracket to a side mounting location you must install the
bottom mounting bracket to a side mounting location.
4. Use the network and InfiniBand cable management harness to secure InfiniBand cables,
network cables, or both.
To remove the network and InfiniBand cable management harness, reverse the installation
procedure.
12 Installing the Network and InfiniBand Cable Management Harness