The Network and InfiniBand Cable Management Harness Installation Guide (572559-doc)

Figure 1-1 Network and InfiniBand Cable Management Harness
1
3
5
6
7
2
4
The following list describes the callouts in Figure 1-1:
1. Top of the HP 10000 Series Rack
2. Top mounting bracket secured to the top of the rack with a #10-32 screw
3. Network and InfiniBand cable management harness mounted to top mounting bracket
with two M6 screws
4. 6.5-inch Velcro strap
5. 13-inch Velcro strap
6. Bottom mounting bracket secured to the bottom of the rack with a #10-32 screw
7. Bottom of the HP 10000 Series Rack
• The fasteners that are specified in Table 1-1.
Table 1-1 Fasteners
DescriptionTorqueFormatSizeQuantity
Machine screw.25-30 in/lbPosidrive#10-32 x 0.5-inch pan
head screws
4
To prevent screws from becoming loose because of vibration, HP recommends that you use
an adjustable torque drive, set to the torque specifications given in the table above. Contact
your HP sales representative if any parts are missing.
8 Preparing for Installation