XC3000 Cluster HP XC Interconnect xx3020 Cabinet Kit Installation Guide

Figure 15: Securing the Hold-Down Bracket
ZK-2074
Front of the Rack
6/32 x .375
Use the following procedure to fasten the hold-down bracket:
a. The hold-down bracket has two threaded inserts that align with two holes
in the right-hand track. Temporarily place the bracket on the outside face
of the track and align it with the holes in the track. This enables you to
identify two recessed screws in the interconnect chassis. Put the bracket
aside and remove the screws from the chassis. (Discard these screws).
b. Attach the bracket to the track loosely by using two M5 x 10 mm screws.
Use only a few turns to hold each screw in the threaded insert.
c. Secure the bracket’s flange to the interconnect chassis loosely by using
two 6/32 x .375 inch (small pan-head) screws using a P1 screwdriver or bit.
d. Tighten all screws to their specified torque.
9. Working at the front of the rack, attach the blanking plate as shown in
Figure 16.
HP XC Interconnect xx3020 Cabinet Kit Install Guide 11