HP Cluster Platform Server and Workstation Overview

Figure 3-8 Removing the HP ProLiant DL145 G2 Access Panel
2
1
DescriptionItem
Access panel screw1
Access panel latch2
3. Slide the cover approximately 1.25 cm (0.5 in) toward the rear of the unit.
4. Pull up the latch to remove the access panel from the chassis.
To replace the access panel and return the server to the rack, reverse the previous steps.
3.1.3 Replacing a PCI card in the HP ProLiant DL145 G1
The HP ProLiant DL145 G1 has one PCI-X expansion slot. To replace the PCI expansion card,
follow these steps:
1. Attach a grounding strap to your wrist or ankle and a metal part of the chassis.
2. Press the Power button to power down the server. When the server powers down, the system
power LED turns off.
3. Disconnect the AC power cord, first from the AC outlet and then from the server.
Note:
The front panel Power button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
4. Remove the server from the rack, as described in Section 3.1.2.
5. Remove the access panel from the server, as shown in Figure 3-8.
6. Disconnect the cable attached to the PCI card.
7. Pull the PCI riser cage upward, as shown in Figure 3-9.
3.1 HP ProLiant DL145 105