HP Cluster Platform Server and Workstation Overview

1. Remove the server from the rack, as described in Section 3.2.1.
2. To detach the access panel from the chassis, follow these steps:
• Loosen the captive screw on the back of the ProLiant DL145 G3 server, as shown by
callout 1 in Figure 3-20. To loosen the screw, HP recommends using the L-shaped wrench
that ships with the server.
Figure 3-20 Removing the HP ProLiant DL145 G3 Access Panel
1
2
DescriptionItem
Access panel screws1
Access panel latch2
3. Slide the cover approximately 1.25 cm (0.5 in) toward the rear of the unit, as shown by callout
2 in Figure 3-20.
4. Use the two circular grips on the top cover to help you slide the cover more easily.
3.2.3 DL145 G3 System Board Expansion Slots
There are four expansion slots on the system board that support four different PCI riser boards.
Figure 3-21 shows the system board expansion slots and Table 3-5 summarizes the types of slots
available on the system board.
3.2 HP ProLiant DL145 G3 115