HP Cluster Platform Server and Workstation Overview

Table 5-11 Supported Memory Configurations (continued)
2 CPU1 CPUMemory Size
EK738AV16 GB (4x4GB) DDR-333
EK737AV32 GB (8x4GB) DDR-333
5.3.9 PCI Card Installation and Removal Instructions
This section describes PCI card installation, and removal procedures for the xw9300 workstation.
Note:
The HP xw9300 Workstation contains two PCI Express x16 slots. PCI Express slot three is only
active in the dual-processor configuration. This slot cannot be used in a single-processor
configuration.
5.3.9.1 PCI Card Support
For added protection, some cards have PCI holders installed to stabilize the card. To remove the
PCI card holder, follow these steps:
1. Disconnect power from the system and remove the access panel.
2. Referring to the callouts in Figure 5-20, for short or tall PCI cards, lift up on the holder arm
(callout 1) with one hand and press in on the sides (callout 2) of the holder and rotate it out
(callout 3) of the chassis.
Figure 5-20 Removing PCI Card Holders
1
3
2
2
To install the PCI card support holder, follow these steps:
1. Disconnect power from the system and remove the access panel.
2. Referring to the callouts in Figure 5-21, for short or tall PCI cards, attach the lips of the
support arm (callout 1) under the slots on the rear of the chassis, then rotate the card support
down until the black part of the arm (callout 2) supports the card.
5.3 HP xw9300 Workstation Overview 231