HP P6000 Cluster Extension Software Administrator Guide (5697-2274, November 2012)

Table 1 Setting resource properties and values in the GUI
ValueDescriptionFormatProperty
Windows Server 2008/2008
R2/2012 GUI: 01:00 mm:ss
(Default)
Used to poll “Alive” state for the resource.
Decreasing this value allows faster
resource failure detection but also
consumes more system resources.
IntegerThorough Resource Health
Check Interval (Windows
Server 2008/2008 R2/
2012)
CLI: 60000 milliseconds
(Default)
Set this value in the Advanced Policies
tab of the resource properties window in
Failover Cluster Management.
IsAlivePollInterval (CLI)
Windows Server 2008/2008
R2/2012 GUI: 00:05 mm:ss
(Default)
Used to poll “Alive” state for the resource.
Decreasing this value allows for faster
resource failure detection but also
consumes more system resources.
IntegerBasic Resource Health Check
Interval (Windows Server
2008/2008 R2/2012)
LooksAlivePollInterval (CLI)
Windows Server 2008/2008
R2/2012 CLI: 5000
milliseconds (Default)
Set this value in the Advanced Policies
tab of the resource properties window in
Failover Cluster Management.
0 (Required)Defines whether a resource can be
automatically restarted after it has failed.
IntegerIf a resource fails, attempt
restart on current node –
Set this value in the Policies tab of the
resource properties window in Failover
Cluster Management.
Maximum restarts in the
specified period (Windows
Server 2008/2008 R2/
2012)
RestartThreshold (CLI)
Windows Server 2008/2008
R2/2012: Check (Required)
Defines whether resources will be failed
over if a restart is unsuccessful.
IntegerIf restart is unsuccessful, fail
over all resources in this
CLI: 2 restart and
affect the group
(Required)
Set this value in the Policies tab of the
resource properties window in Failover
Cluster Management.
service or application
(Windows Server
2008/2008 R2/2012)
RestartAction (CLI)
Windows Server 2008/2008
R2/2012: 15:00 mm:ss
(Default)
Determines the amount of time for restart.
Set this value in the Policies tab of the
resource properties window in Failover
Cluster Management.
IntegerIf a resource fails, attempt
restart on current node –
Period for restarts (Windows
Server 2008/2008 R2/
2012)
CLI: 900000 milliseconds
(Default)
RestartPeriod (CLI)
Windows Server 2008/2008
R2/2012: 03:00 mm:ss
Used to specify the timeout for status
resolution. For more information, see
“Timing considerations for MSCS”
(page 38).
IntegerPending timeout (GUI)
PendingTimeout (CLI)
CLI: 180000 milliseconds
(Default)
Set this value in the Policies tab of the
resource properties window in Failover
Cluster Management.
P6000 Cluster Extension requirements for service or application properties are described in “Service
or application properties and values” (page 25). If no specific value is required, the default value
is listed. Set these values in the Failover tab of the service or application properties window
(Windows Server 2008/2008 R2/2012), or in the CLI. For more information about setting service
or application properties, see your Microsoft documentation.
TIP: To change the properties in “Service or application properties and values” (page 25) with
the CLI, use the following command: cluster group groupname /prop
propertyname="propertyvalue".
Powershell cmdlets can also be used instead of cluster.exe. For more information, see Microsoft
documentation.
24 Configuring P6000 Cluster Extension