Broadcom iSCSI Boot for HP FlexFabric Adapters User Guide
Table Of Contents
- Broadcom iSCSI Boot for HP FlexFabric Adapters User Guide
- Abstract
- Notice
- Contents
- Introduction
- Setup
- iSCSI boot setup
- Configuring the iSCSI target
- Configuring iSCSI boot parameters
- Preparing the iSCSI boot image
- Booting
- Other iSCSI boot considerations
- iSCSI offload in Windows server
- iSCSI boot setup
- Troubleshooting
- Boot fails when switching to Broadcom iSCSI offload
- Broadcom iSCSI Crash Dump utility does not capture a memory dump
- HBA offload miniport BXOIS does not load
- Inbox driver does not update
- Installing Windows on an iSCSI target fails
- IP address conflict
- iSCSI target is not recognized as an installation target
- iSCSI configuration utility does not run
- NDIS miniports with Code 31 yellow-bang after L2 iSCSI boot installation
- System blue screen appears after setting iSCSI boot LUN to 255
- System blue screen occurs when installing through Windows Plug-and-Play
- System blue screen occurs when iSCSI boots Windows 2008 R2
- Frequently asked questions
- Event notifications
- Regulatory compliance notices
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index
Setup 28
11.
On the General tab, select the HP FlexFabric adapter from Local adapter.
12. Click OK to close Advanced settings.
13. Click OK to close the Microsoft Initiator.
14. To format your iSCSI partition, use Disk Manager.
Teaming does not support iSCSI adapters or NDIS adapters that are in the boot path. Teaming supports
NDIS adapters that are not in the iSCSI boot path, but only for the SLB team type.