Broadcom iSCSI Boot for HP FlexFabric Adapters User Guide
Table Of Contents
- Broadcom iSCSI Boot for HP FlexFabric Adapters User Guide
- Abstract
- Notice
- Contents
- Introduction
- Setup
- iSCSI boot setup
- Configuring the iSCSI target
- Configuring iSCSI boot parameters
- Preparing the iSCSI boot image
- Booting
- Other iSCSI boot considerations
- iSCSI offload in Windows server
- iSCSI boot setup
- Troubleshooting
- Boot fails when switching to Broadcom iSCSI offload
- Broadcom iSCSI Crash Dump utility does not capture a memory dump
- HBA offload miniport BXOIS does not load
- Inbox driver does not update
- Installing Windows on an iSCSI target fails
- IP address conflict
- iSCSI target is not recognized as an installation target
- iSCSI configuration utility does not run
- NDIS miniports with Code 31 yellow-bang after L2 iSCSI boot installation
- System blue screen appears after setting iSCSI boot LUN to 255
- System blue screen occurs when installing through Windows Plug-and-Play
- System blue screen occurs when iSCSI boots Windows 2008 R2
- Frequently asked questions
- Event notifications
- Regulatory compliance notices
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index
Event notifications 33
Event notifications
Offload iSCSI driver
The following table lists the offload iSCSI driver event log messages.
Message
Number
Severity Message
1
Error
Initiator failed to connect to the target. Target IP address and TCP port number
are given in dump data.
2
Error Initiator could not allocate resources for an iSCSI session.
3
Error Maximum command sequence number is not serially greater than the expected
command sequence number in login response. Dump data contains Expected
Command Sequence number followed by Maximum Command Sequence
number.
4
Error MaxBurstLength is not serially greater than FirstBurstLength. Dump data contains
FirstBurstLength followed by MaxBurstLength.
5
Error Failed to set up initiator portal. Error status is given in the dump data.
6
Error Initiator could not allocate resources for an iSCSI connection.
7
Error Initiator could not send an iSCSI PDU. Error status is given in the dump data.
8
Error
Target or discovery service did not respond in time for an iSCSI request sent by
the initiator. iSCSI function code is given in the dump data. For details about
iSCSI function code, see the iSCSI user guide.
9
Error Target did not respond in time for a SCSI request. The CDB is given in the dump
data.
10
Error Login request failed. The login response packet is given in the dump data.
11
Error Target returned an invalid login response packet. The login response packet is
given in the dump data.
12
Error Target provided invalid data for login redirect. Dump data contains the data
returned by the target.
13
Error
Target offered an unknown AuthMethod. Dump data contains the data returned
by the target.
14
Error Target offered an unknown digest algorithm for CHAP. Dump data contains the
data returned by the target.
15
Error
The CHAP challenge given by the target contains invalid characters. Dump data
contains the challenge given.
16
Error An invalid key was received during CHAP negotiation. The key=value pair is
given in the dump data.
17
Error CHAP response given by the target did not match the expected one. Dump data
contains the CHAP response.
18
Error Header digest is required by the initiator, but target did not offer it.
19
Error Data digest is required by the initiator, but target did not offer it.
20
Error Connection to the target was lost. The initiator attempts to retry the connection.
21
Error Data Segment Length given in the header exceeds
MaxRecvDataSegmentLength declared by the target.