Broadcom iSCSI Boot for HP FlexFabric Adapters User Guide
Table Of Contents
- Broadcom iSCSI Boot for HP FlexFabric Adapters User Guide
- Abstract
- Notice
- Contents
- Introduction
- Setup
- iSCSI boot setup
- Configuring the iSCSI target
- Configuring iSCSI boot parameters
- Preparing the iSCSI boot image
- Booting
- Other iSCSI boot considerations
- iSCSI offload in Windows server
- iSCSI boot setup
- Troubleshooting
- Boot fails when switching to Broadcom iSCSI offload
- Broadcom iSCSI Crash Dump utility does not capture a memory dump
- HBA offload miniport BXOIS does not load
- Inbox driver does not update
- Installing Windows on an iSCSI target fails
- IP address conflict
- iSCSI target is not recognized as an installation target
- iSCSI configuration utility does not run
- NDIS miniports with Code 31 yellow-bang after L2 iSCSI boot installation
- System blue screen appears after setting iSCSI boot LUN to 255
- System blue screen occurs when installing through Windows Plug-and-Play
- System blue screen occurs when iSCSI boots Windows 2008 R2
- Frequently asked questions
- Event notifications
- Regulatory compliance notices
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index
Regulatory compliance notices 36
Regulatory compliance notices
Safety and regulatory compliance
For safety, environmental, and regulatory information, see Safety and Compliance Information for Server,
Storage, Power, Networking, and Rack Products, available at the HP website
(http://www.hp.com/support/Safety-Compliance-EnterpriseProducts).
Warranty information
HP ProLiant and X86 Servers and Options (http://www.hp.com/support/ProLiantServers-Warranties)
HP Enterprise Servers (http://www.hp.com/support/EnterpriseServers-Warranties)
HP Storage Products (http://www.hp.com/support/Storage-Warranties)
HP Networking Products (http://www.hp.com/support/Networking-Warranties)
Turkey RoHS material content declaration
Ukraine RoHS material content declaration