Broadcom Comprehensive Configuration Management for HP FlexFabric Adapters User Guide

Menu mode 15
General Parameters menu
The General Parameters menu describes the iSCSI boot general parameters available for configuration.
The following table describes iSCSI boot general parameter configuration options.
iSCSI boot parameter Description
TCP/IP Parameters via
DHCP
Enable/disable iSCSI boot initiator to acquire IP address via DHCP
iSCSI Parameters via
DHCP
Enable/disable iSCSI boot initiator to acquire iSCSI target parameters via DHCP
CHAP Authentication
Enable/disable CHAP authentication
Boot to iSCSI target*
Enable/disable device to boot from iSCSI target after successful iSCSI login to iSCSI
target (not applicable for BCV-based iSCSI ROM)
DHCP Vendor ID
Specify DHCP vendor ID
Link Up Delay Time
Specify seconds that iSCSI boot initiator delays before attempting to connect to the
target
Use TCP Timestamp
Enable/disable TCP timestamp
Target as First HDD*
Specify the iSCSI target drive targeted as first HDD in system (not applicable for
BCV-based iSCSI ROM)
LUN Busy Retry Count
Specify number of retry attempts if iSCSI target reports a LUN busy condition
IP Version
Specify IP version
HBA Boot Mode
Enable/disable HBA boot mode (only visible for devices with a valid offload license)
*Feature not supported by HP adapters.