Broadcom Comprehensive Configuration Management for HP FlexFabric Adapters User Guide

Scripting mode 27

Comments

;***********************************************************************

;CCMCFG32 v7.8.21 - Comprehensive Configuration Management

; Dumping Configuration Parameters of Device [00:10:18:6F:D2:74] to

outfile.txt

;***********************************************************************

Characters after a semicolon are treated as comments.

Device block

[Device Parameters]

MAC Address = 00:10:18:6F:D2:74

PCI Function Number = 01:00:00

Device Type = BCM57712

Vendor ID = 0x14E4

Device ID = 0x1662

Subsystem Vendor ID = 0x14E4

Subsystem Device ID = 0x1213

Inside the [Device Parameters] block, only <MAC Address> and <Device ID> keys are used to

specify device scope. The rest of lines are informational descriptions. For details about the device scope

specification, see "Operation device scope (on page 26)."

Section declaration head

The section head format is [section <section name>]:

[Section MBA Configuration Menu]

Option ROM = Disabled

Boot Protocol = Preboot Execution Environment (PXE)

Boot Strap Type = Auto

Hide Setup Prompt = Disabled

Setup Key Stroke = Ctrl-S

Banner Message Timeout = 5 Seconds

Link Speed = 10Gbps

Pre-boot Wake On LAN = Disabled

VLAN Mode = Disabled

VLAN ID = 1

Boot Retry Count = 0

Group declaration head

The group declaration head format is [<group name>]. In the following example, [General

Parameters] is the group declaration head and [Section iSCSI Boot Main Menu] is the section

declaration head. The group head is optional depending on whether the configuration is hierarchical. The

MBA configuration section does not have a group head, but other sections have group heads.

[Section iSCSI Boot Main Menu]