HP Color LaserJet CP6015 Series - Job Aid - Print Banners (PCL 6 Driver)

HP Color LaserJet CP6015 Series Print banners (PCL 6 Driver)

Development Company, L.P.

www.hp.com

How do I Steps to perform

Print banners from Tray 1

The product allows printing of banner-sized paper from Tray

1. You can print banners from 457 mm (18 inches) to 915

mm (36 inches) in length and from 99 mm (4 inches) to 320

mm (12.6 inches) in width. When printing a banner from your

graphics software program, you must set up a custom page

size.

1. Select Print from the File menu of your software

program.

2. Select the HP Color LaserJet CP6015 Series printer,

and then click Properties or Printing Preferences.

3. Click the Paper/Quality tab.

4. Under Paper Options, click Custom, and then type a

name, the width, and the length of the custom paper

size, and then click OK and then OK again to save the

new custom paper size.

5. Click Properties or Printing Preferences again and

then select the new custom paper size in the Paper

Sizes list.

6. Click OK and then OK again to print the banner.

How do I Steps to perform

Load banner paper in Tray 1

1. Go to the product to load the banner paper. The

control panel displays the paper size and prompts you

to load the banner into Tray 1.

2. Gently place the leading edge of the banner into

Tray 1. Hold it there until product starts to pull the

paper in.

NOTE: Hold the paper steady against the paper

sensor of Tray 1 until it feeds into the product. Moving

the paper in an out may cause the product to jam.

3. After the product begins pulling the banner in, let go of

the paper and let the banner feed through on its own.