HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

DescriptionStatusParameter name
Execution cycle of performance monitoring and hardware
tier relocation.
If you specify this parameter, you must also specify
automigration=enable.
One of the following values can be specified.
• 0: 30 minutes
• 1: 1 hour
• 2: 2 hours
• 4: 4 hours
• 8: 8 hours
• 24: 24 hours
You can specify 0 only when the microcode version is
70-02-XX-XX/XX or later.
If this parameter is omitted, 24 is set when
monitoringmode is set to 0 (Periodic), and 1 is set when
monitoringmode is set to 1 (Continuous) .
Optional
(P9500)
migrationinter-
val
Start time of performance monitoring
If you specify this parameter, you must also specify
migrationinterval=24.
Specify a time in the range from 00:00 to 23:59 in HH:MM
format.
If this parameter is omitted, 00:00 is set.
Optional
(P9500)
monitorstart-
time
#3
End time of performance monitoring
If you specify this parameter, you must also specify
migrationinterval=24.
Specify a time in the range from 00:00 to 23:59 in HH:MM
format.
If this parameter is omitted, 23:59 is set.
Optional
(P9500)
monitorendtime
#3
Performance monitoring mode.
If you specify this parameter, you must also specify
tiercontrol=enable.
Specifiable values vary, depending on the microcode
version.
If the microcode version is earlier than 70-02-XX-XX/XX:
0: Periodic
If this parameter is omitted, 0 is set.
If the microcode version is 70-02-XX-XX/XX or later:
0: Periodic
1: Continuous
If this parameter is omitted, 1 is set.
Optional
(P9500)
monitoringmode
#1
If you specify threshold values for overprovisioningwarning and overprovisioninglim-
it, two warning levels related to the over-provisioning percent can be issued. For
XP24000/XP20000, these threshold values are specific to and managed by the Device Manager
server.
Device Manager CLI command reference70