HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

DescriptionStatus
Parameter
name
List of the device numbers of the LUs to be formatted
When you specify multiple device numbers, separate the
numbers by using a comma as a delimiter.
This parameter can be specified in decimal, and in
colon-separated hexadecimal. If you specify a hexadecimal
number, for XP12000/XP10000/SVS200, use the xx:yy
format, where xx is the CU number, and yy is the LDEV
number. For XP24000/XP20000, use the ww:xx:yy format,
where ww is the LDKC number, xx is the CU number, and
yy is the LDEV number. ww is optional. If you omit ww, the
LDKC number is regarded as 0.
The execution results are output in decimal.
Required
devnums
Specifies whether to wait until formatting is complete before
ending the command.
You can specify the following values:
• true: Wait until formatting is complete before ending
the command.
• false: Do not wait until formatting is complete before
ending the command.
If this parameter is omitted, false is set.
If you specify true for this parameter, you cannot specify
true for the quickformat parameter at the same time.
Optional
wait
Specifies whether to format LDEVs whose status is Normal.
You can specify the following values:
• true: Format LDEVs whose status is Normal.
• false: Do not format LDEVs whose status is Normal.
If this parameter is omitted, false is set.
Optional
force
Specifies whether to format the LU by using Quick Format.
You can specify the following values:
• true: Format the LU by using Quick Format.
• false: Do not format the LU by using Quick Format.
If this parameter is omitted, false is set.
If you specify true for this parameter, you cannot specify
true for the wait parameter at the same time.
For XP24000/XP20000, the microcode version required
for formatting the LU by using Quick Format is
60-02-4x-xx/xx or later.
Optional
(P9500 and
XP24000/XP20000)
quickformat
Parameter values to obtain in advance
serialnum and model: Obtain these values from the execution result of the GetStorageArray
command. In the execution result, use the arrayType value or the displayArrayType value to
specify the model parameter, and use the serialNumber value to specify the serialnum parameter.
devnums: Obtain this value from the execution result of the GetStorageArray
(subtarget=LogicalUnit, lusubinfo=LDEV) command. Execute this command by specifying
Device Manager CLI command reference96