HP StorageWorks XP Command View Advanced Edition software Device Manager server installation and configuration guide (web version) (T1780-96078, March 2008)

Windows systems installation

of XP Command View AE Suite products whose versions are earlier than 5.7 are not

stopped automatically.

CAUTION: You must not execute multiple instances of this command concurrently. Also, you

must not execute this command and the cvxpaegetlogs command concurrently.

CAUTION: For details about how to set the port that HiRDB uses, see subsection

5-4-2 .

9. On the standby node, change the setting so that the database on the shared disk is to be used.

Execute the command shown below. Note that before you execute the command, you must

delete or empty the folder that you specify for target-folder-for-storing-data in the command.

When this command is executed, the setting of the port that HiRDB uses will be restored to the

default (23032). If you changed the port number from the default to another number, take a

note of the port number that is being used so that you can set it again later.

<common component installation folder>\bin\hcmdsdbclustersetup

/createcluster /databasepath target-folder-for-re-creating-database

/exportpath target-folder-for-storing-data /auto

For details about the options that can be specified in the hcmdsdbclustersetup command,

see step 8. For databasepath, specify the same folder as target-folder-for-re-

creating-database specified for the executing node.

CAUTION: You must not execute multiple instances of this command concurrently. Also, you

must not execute this command and the cvxpaegetlogs command concurrently.

CAUTION: For details about how to set the port that HiRDB uses, see subsection

5-4-2 .

10. If Common Component is running on both the executing and standby nodes, execute the

following command to stop it:

<common component installation folder>\bin\hcmdssrv /stop

11. In both the executing node and standby node, change the settings so that the following services

start manually.

○ HBase Storage Mgmt Common Service

○ HBase Storage Mgmt Web Service

○ DeviceManagerServer

In the Services screen, open the properties of DeviceManagerServer, and then change Startup

Type from Automatic to Manual.

12. Register the resource in the cluster software.

For details on how to register a cluster resource, see section

3-3-3-3 .

3-5 Verifying and troubleshooting installation of

the Device Manager server and Common

Component

After you complete the installation, you need to verify that the following services are either running

or can be started manually:

• HBase Storage Mgmt Common Service

• HBase Storage Mgmt Web Service

• DeviceManagerServer