HP XP P9000 Replication Manager Software 7.5.0-00 User Guide (TB584-96070, July 2013)

Copy type
Copy pair status in Re-
mote Web Console
Copy pair status in HP
StorageWorks P9000
for Business Continuity
Manager Software
Copy pair state
BC/Cnt Ac-S/Cnt Ac-
A/Cnt Ac-J
SimplexSIMPLEXSimplex (SIMPLEX)
------Unknown
TIP:
As of Replication Manager version 6.3, mainframe pair status information can be obtained using
Device Manager (without HP StorageWorks P9000 for Business Continuity Manager Software or
P9000 mainframe agent installed). Detailed pair state information for mainframe pairs in Device
Manager is equivalent to the information for open systems pairs shown in Table 11.
Legend:
--: Not applicable
Cnt Ac-S: Continuous Access Synchronous
Cnt Ac-A: Continuous Access Asynchronous
Cnt Ac-J: Continuous Access Journal
BC: Business Copy
1. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is SUSPCU, and the status of the secondary volume is SWAPPING,
the copy pair status is displayed as SUSPCU in HP StorageWorks P9000 for Business Continuity
Manager Software and Split (SW) in Replication Manager.
2. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is SUSPER, and the status of the secondary volume is SWAPPING,
the copy pair status is displayed as SUSPER in HP StorageWorks P9000 for Business Continuity
Manager Software and Split (SW) in Replication Manager.
3. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is DUPLEX, and the status of the secondary volume is SWAPPING,
the copy pair status is displayed as PENDING in HP StorageWorks P9000 for Business Continuity
Manager Software and Split (SW) in Replication Manager.
4. Suspending, Copying or Deleting (TRANS) is the actual status, but in Replication Manager
this is abbreviated as Suspending or Deleting (TRANS).
Changing copy pair status
Replication Manager allows you to change the copy pair status in open systems and mainframe
systems. Pair status change operations may be necessary to resume copy operations after recovery
from an error or unexpected pair status changes.
Managing pair life cycle220