HP XP P9000 Replication Manager Software 7.6.0-00 Application Agent CLI Reference Guide

PROMPT> drmcgctl -copy_group VG01,dev01 -mode unlock
• In this example, the command is used to lock the copy groups used for the backup identified by
the backup ID 0000000001:
PROMPT> drmcgctl -backup_id 0000000001 -mode lock
• In this example, the command is used to unlock the copy groups used for the backup identified
by the backup ID 0000000001:
PROMPT> drmcgctl -backup_id 0000000001 -mode unlock
drmclusinit (Registers the parameters for the cluster software)
Formats
To register the parameters for the cluster software:
drmclusinit cluster-software-name
To view the parameters registered for the cluster software:
drmclusinit -v cluster-software-name
Description
For a cluster configuration, the drmclusinit command uses an interactive format to register the
parameters necessary to control the cluster software.
The parameters registered using this command are stored in the following location:
Application-Agent-installation-directory\DRM\conf\cluster\cluster-name.dat
The following table describes the cluster software parameters registered by using the drmclusinit
command.
Table 31 Cluster software parameters
DescriptionRegistered item
Enter the name of the virtual server managed by the cluster software.Virtual server name (required)
Enter the service group name.Resource group name (required)
• For a file system:
Enter a hyphen (-).
• For SQL Server:
Enter the SQL instance name.
• For Exchange Server:
Enter the storage group name.
Name of the instance or application
to be backed up (required)
Enter D.
Resource type
Basic commands110