HP XP P9000 Replication Manager Software 7.6.0-00 Application Agent CLI Reference Guide

-auto_import
Specify this option to automatically transfer a backup catalog to a backup server after backing up a
volume. You must specify this option together with the -s option.
-auto_mount mount-point-directory-name
Specify this option to automatically mount a secondary volume on a backup server after backing up
a volume. You must specify this option together with the -s and -auto_import options.
Specify the mount-point-directory-name parameter by using a character string that is 64 bytes
or less.
If you omit the mount-point-directory-name parameter, a mount destination for the secondary
volume is automatically determined. This destination is determined in the same way as when using
the drmmount command without specifying a mount point.
To unmount the mounted secondary volume, use the drmumount command.
-svol_check
Specify this option to check the status of a secondary volume on a backup server. You must specify
this option together with the -s option. Checking the status of a secondary volume prevents backup
or restoration failures. The items, volumes, and conditions to be checked are described in the following
table.
Table 12 Status check of a secondary volume
Check condition
Volume to be
checked
Check item
Checked when a primary volume is defined in pairs with
multiple generations of secondary volumes and either of the
following applies:
• A primary volume is a cluster resource.
• A primary volume is a dynamic disk.
All secondary
volumes defined for
a backup-target
primary volume
A secondary volume
is hidden from a
backup server
Always checked.
The secondary
volume to be the next
backup destination
A secondary volume
is not mounted on a
backup server
NOTE:
Each piece of backup information in the backup catalog is managed by using a copy group as a
key. Depending on the backup method, you might not be able to perform restoration, even though
the backup data exists on the secondary volume.
For notes on using Application Agent, see the HP P9000 Replication Manager Software Application
Agent CLI User Guide .
Return Values
0: Normal termination
Any value other than 0: Termination with an error
Conditions Causing an Error
This extended command fails in the following cases:
Extended commands52