HP XP7 Command View Advanced Edition Mainframe Agent Installation and Configuration Guide (TK981-96005, May 2014)

Pre-upgrade procedure
Deleting the user SVC
When you upgrade the XP7 mainframe agent, you must delete the user SVC of an earlier XP7
mainframe agent version before installing the new version.
If the user SVC was registered by using the YKALCSVC command, use the YKALCSVC command to
delete the user SVC.
If the user SVC was registered by using the IEASVCxx parmlib member, you cannot use the YKALCSVC
command to delete the user SVC. Instead, you must complete the following procedure. For details on
steps 1 and 2, see the MVS Initialization and Tuning Reference.
1. Comment out the SYMDEF statement for the &YKSVCNO system symbol in the IEASYMxx parmlib
member as follows:
/* SYMDEF(&YKSVCNO='SVC-number') */
2. Use the IEASVCxx parmlib member to disable (comment out) the SVCPARM statement for the
JYUASVC module.
/* SVCPARM SVC-number,REPLACE,TYPE(3),EPNAME(JYUASVC) */
3. Perform IPL with the CLPA parameter specified.
Removing the concatenation of cataloged procedure libraries
Remove the dataset concatenation of the library shown in the table below. If you copied the PROCLIB
library members to a user PROCLIB, delete the copied members.
Table 5 Library for which the dataset concatenation must be removed before performing an upgrade
Library namedd name
Cataloged procedure library PROCLIBIEFPDSI
Removing the concatenation of load libraries
Remove the LPALIB load library linked to LPALST.
Upgrading XP7 mainframe agent
As described in “Pre-installation checks” on page 17 and “Installation procedure” on page 19, install
a new version of XP7 mainframe agent.
Checking settings after upgrading
After upgrading XP7 mainframe agent, make sure that the new settings are the same as those checked
in “Checks before upgrading” on page 24.
Installation and Configuration Guide 25