HP XP7 Command View Advanced Edition Mainframe Agent Installation and Configuration Guide (TK981-96005, May 2014)

Explanation and actionsMessage textMessage ID
The input configuration file identified by file is
unavailable.
dsstate
Status of the input configuration file. The following
messages are output if the attribute of the input config-
uration file is abnormal:
• DSORG = XX. DSORG must be YY
The file is unavailable because the DSORG attribute value
is abnormal. Therefore, delete the current configuration
file, and then recreate a new configuration file that has
correct file attributes.
• RECFM = XX. RECFM must be YY
The file is unavailable because the RECFM attribute value
is abnormal. Therefore, delete the current configuration
file, and then recreate a new configuration file that has
correct file attributes.
• LRECL = XX. LRECL must be YY
The file is unavailable because the LRECL attribute value
is abnormal. Therefore, delete the current configuration
file, and then recreate a new configuration file that has
correct file attributes.
• BLKSIZE = XX. BLKSIZE must be YY
The file is unavailable because the BLKSIZE attribute
value is abnormal. Therefore, delete the current config-
uration file, and then recreate a new configuration file
that has correct file attributes.
• ALLOCATION FAILED
Creation of a configuration file failed. Check the free
device capacity and the available size of VTOC.
• UNAVAILABLE DATASET
The configuration file is being used. Check the usage of
the configuration file.
XX displays the file attribute value that caused the error
and YY displays the correct file attribute value.
file
Name of the configuration file where the error was
detected
File status is:dsstate
YKS086E TSO
SC=44 (file)
YKSTORE (an internal program of YKP2A) processing has
completed.
This message is always displayed.
max-severity
Maximum value among the output severity codes
YKSTORE Processing
Complete.
YKS099I TSO
SC=max-severity
Installation and Configuration Guide 75