HP CommonIO B.11.31.0909 Release Notes

Problems Fixed in Recent Versions
Table 2 HP-UX 11i v3 March 2009 Fixes — CommonIO B.11.31.0903
DescriptionSR Number
Removing a Fibre Channel product bundle and running an application that uses the SNIA
library generates a shl_load/dlopen fail syslog message.
QXCR1000821452
Table 3 HP-UX 11i v3 December 2008 Fixes — CommonIO B.11.31.0812
DescriptionSR Number
The fix delivers the SNIA API HBA_GetFcpTargetMappingV2(), which retrieves
information about the targets mapped through a port on a multi-port Fibre Channel card.
QXCR1000867632
3.2 SAS-COMMON
Table 4 lists the problems fixed in this version of CommonIO.
Table 4 HP-UX 11i v3 September 2009 Fixes — CommonIO B.11.31.0909
DescriptionSR Number
Problem with the sasmgr command with the locate_led option and tape devices.
QXCR1000786865
Problem with sasmgr -f set_attr with rebuild_rate option.
QXCR1000880677
Problem with the sasmgr command, where BDR for all luns fails when an attached device
is in the NO_HW state.
QXCR1000872568
Changes to support online firmware download for AH303A PCIe SC44Ge SAS Host Bus
Adapter and the core-only HP 8 Internal Port SAS Host Bus Adapter.
QXCR1000914229
Problems Fixed in Recent Versions
Table 5 HP-UX 11i v3 March 2009 Fixes — CommonIO B.11.31.0903
DescriptionSR Number
The sasmgr command does not work in HP-UX 11i v3 without legacy mode.
QXCR1000825271
Check that sasmgr replace_tgt command arguments are valid to avoid device access
problems later.
QXCR1000831694
Table 6 HP-UX 11i v3 September 2008 Fixes - CommonIO B.11.31.0809
DescriptionSR Number
Disk firmware download using sasmgr(1M) can fail in a multipath configuration.
QXCR1000786831
4 Known Problems and Limitations
This section provides a list of problems and limitations known to HP when these release notes
were published. If workarounds are available, they are included.
4.1 FC-COMMON
No known problems were identified for this release of the product.
4.2 SAS-COMMON
No known problems were identified for this release of the product.
4