HP Installation Guide, HP AT094A PCIe 2P 8Gb FC and 2P 1/10GbE Adapter, Edition 2

Table 1 AT094A Networking LED indicators
StateGreen LEDYellow LED
Wake-up failure (Dead board)OffOff
POST failure (Dead board)OffOn
Wake-up failure monitorOffSlow Blink
Table 2 AT094A Fibre Channel LED indicators
StateGreen LEDYellow LED
POST failureOffFast Blink
POST processing in progressOffFlashing
Failure while functioningOnOff
Failure while functioningOnOn
2Gb Link rate – Normal, link upOn2 Fast Blinks
4Gb Link rate – Normal, link upOn3 Fast Blinks
8Gb Link rate – Normal, link upOn4 Fast Blinks
Normal – link down or not startedSlow BlinkOff
Off-line for downloadSlow BlinkSlow Blink
Restricted off-line mode (Waiting for restart)Slow BlinkFast Blink
Restricted off-line mode (Test active)Slow BlinkFlashing
Network management
Server integration
• The AT094A adapter is a validated, tested and qualified solution that is optimized for HP
Integrity rx2800 i2 and Superdome2 servers.
PXE (LAN boot)
• Support for pre-boot execution environment (PXE) enables automatic deployment of computing
resources remotely from anywhere.
• Allows a new or existing server to boot over the network and download software, including
the operating system, from a management/ deployment server at another location on the
network.
6 Introduction