HP Installation Guide, HP AT094A PCIe 2P 8Gb FC and 2P 1/10GbE Adapter, Edition 2

3 Installing the HP-UX operating system components
HP-UX operating system
The HP AT094A PCIe 2P 8Gb FC and 2p 1/10GbE adapter is supported through the HP-UX 11i
v3 operating system.
Prerequisites
Before installing the adapter, follow these steps:
1. The adapter card is supported through the HP Integrity rx2800 i2 and Superdome2 server
platforms. Verify compliance with supported configurations using the HP Ethernet System-Driver
Support Matrix and the HP-UX Fibre Channel (fcd, fclp) and FlexFabric FCoE (fcoc) Host Bus
Adapter Support Matrix at the following website:
http://www.hp.com/go/hpux-iocards-docs
2. Ensure that your system meets the following minimum software and firmware requirements:
• HP Integrity rx2800 i2 — Recipe S26.21, HP-UX B.11.31.1109 or later
• HP Superdome2 — Minimum Firmware Bundle Required 2.51.102, HP-UX B.11.31.1109
or later
Information for HP Integrity servers is available at the following website:
http://welcome.hp.com/country/us/en/prodserv/servers.html
IMPORTANT: This document contains minimum firmware requirements; HP strongly advises
that you check for the latest versions of firmware that are available for your systems.
1. Go to http://www.hp.com.
2. Locate and click the Support & Drivers link on the main page.
3. Click the button next to Download drivers and software (and firmware).
4. Enter your product name (for example, Superdome 2) or number and click >>.
5. After selecting the correct product, choose the OS or Cross operating system (BIOS,
Firmware, Diagnostics, etc.)
6. Refer to the Release Notes or Installation Instructions to verify the firmware version.
3. Confirm that the server model and operating system are supported with the AT094A adapter.
Also, determine the required versions for the system firmware, adapter firmware, and UEFI
driver.
For more information, see the HP-UX Ethernet Card Support Matrix at:
www.hp.com/go/integrity-iocards-docs
and also see the HP-UX Fibre Channel (fcd, fclp) and FlexFabric FCoE (fcoc) Host Bus Adapter
Support Matrix at: www.hp.com/go/fibre-channel-HBA-docs
Support Matrix documents are listed alphabetically in the “General reference” section.
HP-UX operating system 9