HP 2U Rack Rail Kit installation instructions (536846-001, September 2009)

HP 2U Rack Rail Kit installation

instructions

First edition: June 2009

The information in this document is subject to change without notice.

Printed in the US

www.hp.com

*536846-001*

Overview

This document contains instructions for installing HP rack rails into square

and round hole racks for HP devices.

NOTE:

For more information on preparing the device for installation,

see the user guide that ships with the device.

Kit contents

• Two rack rails (left and right)

• Mounting hardware for square and round hole racks

• Two tie wraps

NOTE:

If mounting the device into threaded hole or telco racks, please

see w

ww.racksolutions.com to purchase mounting hardware.

Important safety information

See the Important Safety Information document included with the device.

CAUTION:

Electrostatic discharge (ESD) can damage electronic

components. Be sure you are properly grounded (earthed)

before beginning any installation procedure.

Page 1

PAGE 1
HP 2U Rack Rail Kit installation instructions Overview This document contains instructions for installing HP rack rails into square and round hole racks for HP devices. NOTE: For more information on preparing the device for installation, see the user guide that ships with the device. Kit contents • Two rack rails (left and right) • Mounting hardware for square and round hole racks • Two tie wraps NOTE: If mounting the device into threaded hole or telco racks, please see www.racksolutions.
PAGE 2
Installation guidelines Installation procedures This installation is to be performed by qualified individuals who have knowledge of the procedures, precautions, and hazards associated with equipment containing hazardous electrical circuits. 1. Position left and right rack rails at the desired 'U' position in the rack, adjusting the rails to fit the rack, as needed (1). 2. Secure rack rails to the front and back rack columns using screws.
PAGE 3
NOTE: The rear ends of the rails have a CTO bracket that must engage the device chassis to secure the rear of the chassis to the rails. nl 4. When cabling the device, use holes provided in the rear rack rails, install tie wraps, and route external cable as required.